# TODO

## Before calling v2.0 done

- [ ] **Wyse 3040 validation.** Debian minimal to working rack display,
      following only the README. Every stumble is a README fix, then re-run.
      This is the acceptance gate, not a nice-to-have.
- [ ] Switch the LattePanda over from v1. Its v2 config path and session name
      differ, so both can be installed side by side while testing.
- [ ] Add the tested-hardware table to the README once the Wyse is done.
- [ ] Decide on the position indicator (`indicator: true`). Implemented; keep or
      cut based on whether it actually helps on the wall.

## Open questions from the plan

- **Snap tie-break.** From `0x2`, with cells at `-1x1` and `-1x3` both at
  distance 1, the lower column wins. Only fires on the first entry into a row.
- **Indicator.** Off by default. See above.

## Later

- Prebuilt binaries. Deliberately not in v2.0: source-only until the Wyse install
  shows how bad a build on an Atom really is. `[package.metadata.deb]` is already
  in `Cargo.toml`, so `cargo deb` is the cheap next step if it turns out to hurt.
- `unifly` parameters. `site` and `controller` are accepted by the config and
  passed as `--site` / `--controller`, but the fork does not implement them yet.
  Verify against the flags it actually grows.
- A second monitor type that needs a multi-pane sub-sequence would prove the
  `Vec<Pane>` model generalises. Nothing needs it yet.
- SIGTERM handling to remove the control socket on exit. Not urgent: a stale
  socket is detected and replaced on the next start, which is tested behaviour.